Plastic mold purchase these six requirements can not be ignored 2019-05-10

The plastic mold is an abbreviation for a combined mold for compression molding, extrusion molding, injection molding, blow molding and low foam molding. The coordinated changes of the mold convex and

What is the impact of the temperature of the plastic mold on the product? 2019-05-10

The temperature of the plastic mold can be an important part of injection molding. If the temperature of the plastic mold is well controlled, the processed product will be a good product; and if the t

These seven strokes can effectively solve the common defects in mold processing. 2019-05-10

During the processing of the mold, the most troublesome thing for everyone is the common defects. These defects will directly lead to the use performance of the workpiece, and even the workpiece canno

Temperature control of plastic mold processing injection molding 2019-05-10

Plastic mold processing In the injection molding, temperature control occupies a very important part, it can decide whether the product is good or bad. If you make it to the customer, you will lose th

Prevention of damage during processing of plastic molds 2019-05-10

How to prevent damage during the processing of plastic molds, we must improve our own strength if we want to prevent damage. If there is no strength, ..

How to improve quality in the process of plastic mold manufacturing 2019-05-10

Plastic mold manufacturing is a very complicated process. From the initial design, processing, assembly, commissioning and other steps to the final use, the impact of each process on the quality of pl

Corresponding measures for injection molding on the film during injection molding 2019-05-10

Corresponding measures for injection molding on the film during injection moldingthe reason 1. Injection pressure or barrel temperature 2. Too much feed 3. The mast is going too long. 4. Write more an

Plastic injection mold copper public and front and back mold processing method 2019-05-10

Before writing the knife path, after the stereo picture is finished, the center of the figure should be moved to the origin of the coordinate, and the highest point is moved to Z=0. After the shrinkag

Plastic mold life and injection mold structure design 2019-05-10

Die life and mold structure designDie life is a comprehensive reflection of mold design, mold material performance, mold manufacturing level, mold heat treatment level, and use and maintenance levels